Raising ShorePort Keel Rollers
ShorePort Keel Rollers may be adjusted to fit the customer's specific PWC model.
When additional lift is needed, you may add Spacer Plates that raise the keel roller an additional 1/2".
| Part Number 1003475 | Keel Roller Spacer Plate Assembly (each) *used to raise roller 1/2" |
Sold as a pair.
Customers may install using Roller Adjustment Instructions, on Page 3:
Related Articles
ShorePort/PolyDock Section Troubleshooting
The ShorePort supports up to 1150lb and is 58" W and 138" L. If the fueled up PWC falls within those specs, the ShorePort fails to stay afloat, it may taking on water. If the PWC is over 1150lbs, you may add supplemental flotation up to 1450lbs. Each ...
ShorePort Keel Roller Assembly Installation Hardware
The following PNs are required, (but not included,) per keel roller assembly installation:
ShorePort Flexi-Hinge Conversion from Parallel (Side) Mount to Perpendicular (Front) Mount
A set of Side Mount ShorePort Flexi-Hinges, (PN 1013365,) may be converted into Front Mount, (PN 1007015,) hinges for Perpendicular application. You will need to convert the Rear hinge into a Front hinge. To do so: -Remove the 5.875" Poly ...
ShorePort Flexi-Hinge Conversion from Perpendicular (Front) Mount to Parallel (Side) Mount
A set of Front Mount ShorePort Flexi-Hinges (PN 1007015) may be converted into Side Mount (PN 1013365) hinges for Parallel applications. You will need to convert 1 (one) of the 2 (two) Front hinges into a Rear hinge. To do so, -Remove the 13 ...
Comparing Infinity Boat Lift Models
Vertical Lifts Pontoon Lifts Hydraulic Lifts PWC Lifts ShorePort Frame Construction Welded Aluminum Welded Aluminum Welded Aluminum Welded Aluminum Rotomolded Plastic Lifting Style Vertical Vertical Cantilever Vertical and Cantilever Drive-On Rack ...